DTC P0327 Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor) |
DTC P0328 Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0327 | Output voltage of knock sensor 0.5 V or less for 1 second or more (1 trip detection logic) |
|
| P0328 | Output voltage of knock sensor 4.5 V or more for 1 second or more (1 trip detection logic) |
|

| ECM Terminal Name | Between KNK1 and EKNK |
| Tester Range | 1 V/DIV., 1 ms./DIV. |
| Condition | Engine speed maintained at 4000 rpm after warming up engine |
| Frequency of Operation | Continuous |
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ VALUE USING INTELLIGENT TESTER (KNOCK FEEDBACK VALUE) |
Connect the intelligent tester to the DLC3.
Start the engine.
Turn the tester on.
Warm up the engine.
Enter the following menus: Powertrain / Engine and ECT / Data List / Knock Feedback Value.
Read the value while driving the vehicle.
| Malfunction does not occur | Knock Feedback Value changes |
| Malfunction occurs | Knock Feedback Value does not change |
|
| ||||
| OK | ||
| ||
| 2.INSPECT ECM (KNK1 VOLTAGE) |
![]() |
Disconnect the knock sensor connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| R1-1 - R1-2 | Ignition switch ON | 4.5 to 5.5 V |
| *a | Front view of wire harness connector (to Knock Sensor) |
|
| ||||
| OK | |
| 3.INSPECT KNOCK SENSOR |
Inspect the knock sensor (Click here).
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (ECM - KNOCK SENSOR) |
Disconnect the knock sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R1-2 - B84-110 (KNK1) | Always | Below 1 Ω |
| R1-1 - B84-111 (EKNK) | Always | Below 1 Ω |
| R1-2 or B84-110 (KNK1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||