Home › Vehicle Interior › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)

FRONT SEAT INNER BELT ASSEMBLY (for Driver Side) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here). (w/ Front Seat Side Airbag)

NOTICE:
Always use "TORX" socket wrench E10 when removing the front seat.

HINT:
The procedure described below is for the LHD. Use the same procedure for both RHD and LHD, unless otherwise specified.



1. PRECAUTION (w/ Front Seat Side Airbag)

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE FRONT SEAT ASSEMBLY
(Click here)


4. REMOVE FRONT SEAT INNER BELT ASSEMBLY


    B283284
  1. Remove the 4 clips and the front seat cushion cover. (for LHD)



    B286793
  1. Disengage the 5 clamps.



    B286761
  1. Disengage the 2 clamps. (for 6 Way Seat Type)

  1. Remove the bolt and the front seat inner belt assembly. (for 6 Way Seat Type)



    B288263
  1. Disengage the clamp. (for 4 Way Seat Type)

  1. Remove the bolt and the front seat inner belt assembly. (for 4 Way Seat Type)