Home › General › INTRODUCTION › REPAIR INSTRUCTION

REPAIR INSTRUCTION > INITIALIZATION



PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED

Procedures Necessary when ECU or Other Parts are Replaced 
Replacement Part
Necessary Procedure
Effect or Inoperative Function when Necessary Procedure is not Performed
See Page
ECM
ECU communication ID registration
Engine start
Click here for Precaution (1NZ-FE)
Click here for Precaution (2NZ-FE)
Throttle with motor body assembly, cleaning any throttle body components or
Initialization (throttle position)
Rough idle
Automatic transaxle assembly, engine assembly or ECM
  1. Reset memory (AT initialization)
  2. Road test
Large shift shock
Click here for Initialization (U340E)
for Initialization (U441E)
w/ VSC
  1. Yaw rate sensor (Airbag sensor assembly)*1
Yaw rate and deceleration sensor zero point calibration
  1. Warning light comes on
  2. The deterioration of fuel efficiency
Click here for Calibration (vehicle stability control system)
w/ VSC
  1. Yaw rate deceleration sensor (Yaw rate sensor)*2
Yaw rate and deceleration sensor zero point calibration
  1. Warning light comes on
  2. The deterioration of fuel efficiency
Click here for Calibration (vehicle stability control system)
w/ VSC
  1. Brake actuator assembly (Skid control ECU)
  1. Yaw rate and deceleration sensor zero point calibration
  1. Warning light comes on
  2. The deterioration of fuel efficiency
Click here for Calibration (vehicle stability control system)*1
Click here for Calibration (vehicle stability control system)*2
  1. Power steering ECU assembly
  2. Power steering motor assembly
  3. Steering column assembly (containing the torque sensor)
  1. Torque sensor zero point calibration
  2. Assist map writing
  1. Warning light comes on
  2. Power assist stops
Click here for Calibration (power steering system)
  1. Door control receiver
  2. Key
Registration of recognition codes
Wireless door lock control system
Click here for Registration (wireless door lock control system)
  1. Transponder key ECU
  2. Key
  3. ECM
  1. ECU communication ID registration
  2. Key code registration
Engine start
Refer to the Service Bulletin for the registration procedure.
Power window regulator motor
Motor initialization
  1. Jam protection function
  2. Power window control system
Click here for Initialization (Power window control system)
  1. *1: for Built-in Type Yaw Rate Sensor
  2. *2: for Separate Type Yaw Rate Sensor