Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)

DTC    B1451    Compressor Solenoid Circuit

for Preparation Click here


DESCRIPTION

In this circuit, the compressor with pulley assembly receives a refrigerant compression demand signal from the air conditioning amplifier assembly.
Based on this signal, the compressor with pulley assembly changes the amount of compressor output.

DTC No.
DTC Detection Condition
Trouble Area
B1451
An open or short in the cooler compressor solenoid circuit.
  1. Compressor with pulley assembly
  2. Harness or connector
  3. Air conditioning amplifier assembly

WIRING DIAGRAM


E227902E01


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Air Conditioner / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Air Conditioner 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Regulator Control Current
    Regulator control current /
    Min.: 0 A
    Max.: 0.997 A
    Value changes between 0.12 A and 0.997 A in accordance with compressor operation
    -

    OK:
    The display is as specified in the normal condition column.

    Result 
    Result
    Proceed to
    OK (When troubleshooting according to the DTC)
    A
    OK (When troubleshooting according to Problem Symptoms Table)
    B
    NG
    C



B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
Go to step 3
A


2.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    B1451 is not output



NG
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)  

3.INSPECT COMPRESSOR WITH PULLEY ASSEMBLY
  1. Inspect the compressor with pulley assembly (Click here).



NG
REPLACE COMPRESSOR WITH PULLEY ASSEMBLY (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (COMPRESSOR WITH PULLEY ASSEMBLY - AIR CONDITIONING AMPLIFIER ASSEMBLY)
  1. Disconnect the B77 compressor with pulley assembly connector.

  1. Disconnect the F41 air conditioning amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    B77-2 (SOL+) - F41-11 (SOL+)
    Always
    Below 1 Ω
    B77-2 (SOL+) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK HARNESS AND CONNECTOR (COMPRESSOR WITH PULLEY ASSEMBLY - BODY GROUND)


    E103260E01
  1. Disconnect the B77 compressor with pulley assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    B77-1 (SOL-) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Compressor with Pulley Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)