DTC P0340 Camshaft Position Sensor Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0340 | When one of following conditions is met:
|
|
| Required Sensors/Components (Main) | Camshaft position sensor |
| Required Sensors/Components (Related) | Crankshaft position sensor |
| Frequency of Operation | Continuous |
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0340) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read DTCs.
| Result | Proceed to |
| DTC P0340 is output | A |
| DTC P0340 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT CAMSHAFT POSITION SENSOR |
Inspect the camshaft position sensor (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CAMSHAFT POSITION SENSOR - ECM) |
Disconnect the camshaft position sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B30-1 - B84-99 (VV1+) | Always | Below 1 Ω |
| B30-2 - B84-121 (NE-) | Always | Below 1 Ω |
| B30-1 or B84-99 (VV1+) - Body ground | Always | 10 kΩ or higher |
| B30-2 or B84-121 (NE-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK SENSOR INSTALLATION (CAMSHAFT POSITION SENSOR) |
![]() |
Check the camshaft position sensor installation.
| *a | OK |
| *b | NG |
| *c | Clearance |
|
| ||||
| OK | |
| 5.CHECK VALVE TIMING |
![]() |
Remove the cylinder head cover.
Turn the crankshaft pulley, and align its groove with the timing mark "0" on the timing chain cover.
Check that the timing marks on the camshaft timing sprocket and camshaft timing gear are facing upward as shown in the illustration.
| *a | Timing Marks (at top center of each gear) |
| *b | Timing Mark (groove on crankshaft pulley) |
|
| ||||
| OK | |
| 6.INSPECT INTAKE CAMSHAFT (TIMING ROTOR) |
Inspect the timing rotor of the intake camshaft.
|
| ||||
| OK | |
| 7.REPLACE CAMSHAFT POSITION SENSOR |
Replace the camshaft position sensor (Click here).
| NEXT | |
| 8.CHECK WHETHER DTC OUTPUT RECURS (P0340) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Clear DTCs (Click here).
Start the engine.
Idle the engine for 10 seconds or more.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the pending DTCs.
| Result | Proceed to |
| DTC P0340 is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||