Home › Engine / Hybrid System ยท 1NZ-FE › ENGINE CONTROL › ECM

ECM > REMOVAL

for Preparation Click here



1. REMOVE WINDSHIELD WIPER MOTOR AND LINK
(Click here)


2. REMOVE FRONT NO. 1 VENTILATOR SEAL (for LHD)


C242062
  1. Disengage the clamp and remove the front No. 1 ventilator seal.



3. REMOVE FRONT NO. 1 VENTILATOR SEAL (for RHD)


A249556
  1. Disengage the clamp and remove the front No. 1 ventilator seal.



4. REMOVE FRONT AIR SHUTTER SEAL RH (for LHD)

HINT:
Use the same procedure as for the No. 1 ventilator seal.



5. REMOVE FRONT AIR SHUTTER SEAL RH (for RHD)

HINT:
Use the same procedure as for the No. 1 ventilator seal.



6. REMOVE INNER COWL TOP TO COWL BRACE (for LHD)


C242063
  1. Remove the 2 bolts and the inner cowl top to cowl brace.



7. REMOVE INNER COWL TOP TO COWL BRACE (for RHD)


A249554
  1. Remove the 2 bolts and the inner cowl top to cowl brace.



8. REMOVE OUTER COWL TOP PANEL (for LHD)


C242064
  1. Disengage the 2 clamps and separate the wire harness.



  1. Remove the 8 bolts and the outer cowl top panel.


    C242065



9. REMOVE OUTER COWL TOP PANEL (for RHD)


A249552
  1. Disengage the 2 clamps and separate the wire harness.



  1. Remove the 8 bolts and the outer cowl top panel.


    A249553



10. REMOVE BATTERY (for RHD)


A248909
  1. Disconnect the cable from the battery terminal.

  1. Loosen the 2 nuts and remove the battery clamp.

  1. Remove the battery.



11. REMOVE BATTERY TRAY (for RHD)


12. REMOVE BATTERY CARRIER (for RHD)


A247997
  1. Disengage the 7 wire harness clamps and separate the wire harness from the battery carrier.

  1. Remove the 5 bolts and the battery carrier.



13. REMOVE ECM


    A107404
  1. Pull up the lever to loosen the lock and disconnect the 2 connectors from the ECM.

    NOTICE:
    If there are is any foreign matter such as mud or water on a connector, clean the connector.



    A105635
  1. Remove the bolt and nut, then remove the ECM.



14. REMOVE NO. 1 ECM BRACKET


    A260835
  1. Remove the 2 screws and No. 1 ECM bracket.



15. REMOVE NO. 2 ECM BRACKET


    A260836
  1. Remove the 2 screws and No. 2 ECM bracket.