Home › Engine / Hybrid System ยท 1NZ-FE › STARTING › IGNITION SWITCH

IGNITION SWITCH > REMOVAL

for Preparation Click here



1. REMOVE STEERING COLUMN ASSEMBLY
(Click here)


2. REMOVE IGNITION OR STARTER SWITCH ASSEMBLY


A250755E01

NOTICE:
  1. Perform the operation after situating the upper steering column bracket assembly in such a way that the ignition or starter switch assembly faces upward, as shown in the illustration.
  2. Do not turn the upper steering column bracket assembly sideways or downward because doing so might release the upper steering column bracket assembly's component parts.

Text in Illustration 
*1
Ignition or Starter Switch Assembly


    A248261
  1. Disconnect the connector.

  1. Disengage the 2 claws and remove the ignition or starter switch assembly.