STEERING COLUMN ASSEMBLY (for LHD) > REMOVAL |
| 1. PRECAUTION |
| 2. POSITION FRONT WHEELS FACING STRAIGHT AHEAD |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE STEERING PAD |
| 5. REMOVE STEERING WHEEL ASSEMBLY |
![]() |
Remove the steering wheel assembly set nut.
Put matchmarks on the steering wheel assembly and the steering main shaft.
| *a | Matchmark |
Disconnect the connectors from the spiral cable.
![]() |
Using SST, remove the steering wheel assembly.
| *a | Hold |
| *b | Turn |
| 6. REMOVE LOWER STEERING COLUMN COVER |
![]() |
Remove the 3 screws.
![]() |
Disengage the 4 claws and remove the lower steering column cover.
| 7. REMOVE UPPER STEERING COLUMN COVER |
![]() |
Disengage the claw and remove the upper steering column cover.
| 8. REMOVE COMBINATION SWITCH ASSEMBLY |
Disconnect all connectors from the combination switch assembly.
![]() |
Use pliers to hold the clamp and raise the claw with a screwdriver. Remove the combination switch assembly from the steering column assembly.
| 9. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY |
| 10. REMOVE COLUMN HOLE COVER SILENCER SHEET |
![]() |
Remove the 2 clips and the column hole cover silencer sheet.
| 11. REMOVE STEERING SLIDING YOKE SUB-ASSEMBLY |
![]() |
Place matchmarks on the No. 2 steering intermediate shaft assembly and the steering column assembly.
| *1 | No. 2 Steering Intermediate Shaft Assembly |
| *2 | Steering Sliding Yoke Sub-assembly |
| *a | Matchmark |
Place matchmarks on the steering sliding yoke sub-assembly and the steering gear assembly.
Loosen bolt A.
Loosen bolt C.
Remove bolt B and detach the steering sliding yoke sub-assembly from the steering gear assembly.
| 12. REMOVE STEERING COLUMN ASSEMBLY |
![]() |
Separate the wire harness clamp from the power steering ECU assembly.
Disconnect the 2 steering column assembly connectors from the power steering ECU assembly.
Disconnect all connectors and detach all wire harness clamps from the steering column assembly.
![]() |
Remove the bolt, 2 nuts and the steering column assembly from the instrument panel reinforcement assembly.