Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Front Door)

POWER WINDOW REGULATOR MOTOR (for Front Door) > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side)

NOTICE:
  1. Do not apply voltage to any terminals except terminals 1 and 2, to avoid damaging the pulse sensor inside the motor.
  2. Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly onto the door (Click here).



  1. Apply battery voltage to the motor connector according to the table below.


    B172246E04


    Text in Illustration 
    *A
    for LHD
    *B
    for RHD
    *1
    Motor Gear
    -
    -
    *a
    Counterclockwise
    *b
    Clockwise
    *c
    Component without harness connected
    (Power Window Regulator Motor (Driver Side))
    -
    -

    OK:
    Switch Condition
    Measurement Condition
    Specified Condition
    Manual Operation
    Battery positive (+) → Terminal 2 (B)
    Battery negative (-) → Terminal 1 (E), 7 (DWN1)
    Motor gear rotates counterclockwise
    Battery positive (+) → Terminal 2 (B)
    Battery negative (-) → Terminal 1 (E), 10 (UP1)
    Motor gear rotates clockwise
    Auto Operation
    Battery positive (+) → Terminal 2 (B)
    Battery negative (-) → Terminal 1 (E), 4 (AUTO), 7 (DWN1)
    Motor gear rotates counterclockwise
    Battery positive (+) → Terminal 2 (B)
    Battery negative (-) → Terminal 1 (E), 4 (AUTO), 10 (UP1)
    Motor gear rotates clockwise

    If the result is not as specified, replace the power window regulator motor assembly.



2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front Passenger Side)


  1. Apply battery voltage to the motor connector according to the table below.


    B272442E02


    Text in Illustration 
    *A
    for LHD
    *B
    for RHD
    *1
    Motor Gear
    -
    -
    *a
    Counterclockwise
    *b
    Clockwise
    *c
    Component without harness connected
    (Power Window Regulator Motor (Front Passenger Side))
    -
    -

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 1
    Battery negative (-) → 2
    Motor gear rotates clockwise
    Battery positive (+) → 2
    Battery negative (-) → 1
    Motor gear rotates counterclockwise

    If the result is not as specified, replace the power window regulator motor assembly.