VEHICLE STABILITY CONTROL SYSTEM (for Separate Type Yaw Rate Sensor) > CALIBRATION |
| DESCRIPTION |
| Replacing Part/Operation | Necessary Operation |
| Skid control ECU (brake actuator assembly) | Yaw rate and deceleration sensor zero point calibration |
| Yaw rate and deceleration sensor (yaw rate sensor) | Yaw rate and deceleration sensor zero point calibration |
| OBTAIN ZERO POINT OF YAW RATE AND DECELERATION SENSOR (When Using Intelligent Tester) |
Clear the zero point calibration data.
Turn the ignition switch off.
Check that the steering wheel is in the straight-ahead position.
Check that the shift lever is in neutral and apply the parking brake.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Select the skid control ECU (brake actuator assembly) to clear the zero point calibration data using the intelligent tester.
Enter the following menus: Chassis / ABS/VSC/TRC / Utility / Reset Memory.
Check that the Slip indicator light comes on.
Turn the ignition switch off.
Perform zero point calibration of the yaw rate and deceleration sensor.
Turn the ignition switch off.
Check that the steering wheel is in the straight-ahead position.
Check that the shift lever is in neutral and apply the parking brake.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Switch the skid control ECU (brake actuator assembly) to Test Mode using the intelligent tester.
Enter the following menus: Chassis / ABS/VSC/TRC / Utility / Test Mode.
After the Test Mode has been entered, keep the vehicle stationary on a level surface for 5 seconds or more.
Check that the Slip indicator light comes on for several seconds and then blinks in Test Mode.
Turn the ignition switch off and disconnect the intelligent tester.
| OBTAIN ZERO POINT OF YAW RATE AND DECELERATION SENSOR (When not Using Intelligent Tester) |
Clear the zero point calibration data.
Turn the ignition switch off.
Check that the steering wheel is in the straight-ahead position.
Check that the shift lever is in neutral and apply the parking brake.
Turn the ignition switch to ON.
The warning light and indicator light come on for 3 seconds to indicate that the initial check is completed.
![]() |
Using SST, connect and disconnect terminals 12 (TS) and 4 (CG) of the DLC3 4 times or more within 8 seconds.
| *a | Front view of DLC3 |
Check that the Slip indicator light comes on.
Perform zero point calibration of the yaw rate and deceleration sensor.
Turn the ignition switch off.
Check that the steering wheel is in the straight-ahead position.
Check that the shift lever is in neutral and apply the parking brake.
![]() |
Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.
| *a | Front view of DLC3 |
Turn the ignition switch to ON.
After Test Mode has been entered, keep the vehicle stationary on a level surface for 5 seconds or more.
Check that the Slip indicator light comes on for several seconds and then blinks in Test Mode.
Turn the ignition switch off and disconnect SST from the DLC3.