DTC C146E Open in ABS Solenoid Relay Circuit |
DTC C146F Short in ABS Solenoid Relay Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C146E | When either of the following is detected:
|
|
| C146F | Immediately after the ignition switch is turned to ON, the solenoid relay contact is closed for 4 seconds when the relay is turned off. |
|
| 1.CHECK TERMINAL VOLTAGE (+BS TERMINAL) |
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
Check the connector case and terminals for deformation and corrosion.
![]() |
Disconnect the brake actuator assembly (skid control ECU) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A55-12 (+BS) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Skid control ECU) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (GND1 TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A55-1 (GND1) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Skid control ECU) |
Reconnect the skid control ECU (brake actuator assembly) connector.
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Clear the DTC (Click here).
Start the engine.
Drive the vehicle at the speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output (for LHD) | B |
| DTC is output (for RHD) | C |
|
| ||||
|
| ||||
| A | ||
| ||