Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (for Built-in Type Yaw Rate Sensor)

VEHICLE STABILITY CONTROL SYSTEM (for Built-in Type Yaw Rate Sensor) > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Connecting terminals TC and CG of the DLC3 causes the ECU to display the DTC by blinking the ABS warning light and Slip indicator light.

WIRING DIAGRAM


C243297E01

HINT:
When the warning lights continue to blink, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in one or more ECUs is suspected.


INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly. perform zero point calibration (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication system DTCs are output (Click here).

Result 
Result
Proceed to
DTC is not output
A
DTC is output
B


B
CHECK CAN COMMUNICATION SYSTEM (Click here)
A


2.INSPECT DLC3


    C146309E87
  1. Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F4-13 (TC) - F4-4 (CG)
    Ignition switch ON
    11 to 14 V

Result 
Result
Proceed to
NG
A
OK
B
Text in Illustration 
*a
Front view of DLC3


B
Go to step 5
A


3.CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM)
  1. Turn the ignition switch off.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F4-13 (TC) - A74-27 (TC)
    Always
    Below 1 Ω
    F4-13 (TC) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F4-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.INSPECT ECM (TC of DLC3 INPUT)


    C146309E88
  1. Turn the ignition switch off.

  1. Using SST, connect terminals TC and CG of the DLC3.

  1. Turn the ignition switch to ON.

  1. Check that the malfunction indicator lamp is blinking.

Text in Illustration 
*a
Front view of DLC3
Result 
Result
Proceed to
Malfunction indicator lamp is blinking
A
Malfunction indicator lamp is not blinking
B


B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
A

REPAIR OR REPLACE WIRE HARNESS OR ECM (TC of ECM CIRCUIT)