VEHICLE STABILITY CONTROL SYSTEM (for Built-in Type Yaw Rate Sensor) > TS and CG Terminal Circuit |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.INSPECT DLC3 |
![]() |
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| F4-13 (TC) - F4-4 (CG) | Ignition switch ON | 11 to 14 V |
| Result | Proceed to |
| NG | A |
| OK | B |
| *a | Front view of DLC3 |
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (TS of DLC3 - POWER STEERING ECU ASSEMBLY) |
Turn the ignition switch off.
Disconnect the power steering ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F4-12 (TS) - F6-6 (TS) | Always | Below 1 Ω |
| F4-12 (TS) - Body ground | Always | 10 kΩ or higher |
Reconnect the power steering ECU connector.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F4-4 (CG) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.INSPECT POWER STEERING ECU ASSEMBLY |
![]() |
Turn the ignition switch off.
Using SST, connect terminals TS and CG of the DLC3.
Turn the ignition switch to ON.
Check that the PS warning light is blinking.
| *a | Front view of DLC3 |
| Result | Proceed to |
| The PS warning light is not blinking | A |
| The PS warning light is blinking | B |
|
| ||||
| A | ||
| ||