POWER WINDOW CONTROL SYSTEM > Rear Power Window LH does not Operate with Rear Power Window Switch LH |

| 1.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH |
Inspect the rear power window regulator switch assembly LH (Click here).
|
| ||||
| OK | |
| 2.INSPECT REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH |
Inspect the rear power window regulator motor assembly LH (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH - P/W RELAY) |
![]() |
Disconnect the J1 rear power window regulator switch assembly LH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| J1-3 (B) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Rear Power Window Regulator Switch Assembly LH) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH - REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH) |
Disconnect the J1 rear power window regulator switch assembly LH connector.
Disconnect the J2 rear power window regulator motor assembly LH connector.
Measure the resistance according the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J1-4 (U) - J2-1 (U) | Always | Below 1 Ω |
| J1-1 (D) - J2-2 (D) | Always | Below 1 Ω |
| J1-4 (U) - Body ground | Always | 10 kΩ or higher |
| J1-1 (D) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY LH - POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY) |
for LHD
Disconnect the J1 rear power window regulator switch assembly LH connector.
Disconnect the H1 power window regulator master switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J1-5 (SU) - H1-12 (U) | Always | Below 1 Ω |
| J1-2 (SD) - H1-13 (D) | Always | Below 1 Ω |
| J1-5 (SU) - Body ground | Always | 10 kΩ or higher |
| J1-2 (SD) - Body ground | Always | 10 kΩ or higher |
for RHD
Disconnect the J1 rear power window regulator switch assembly LH connector.
Disconnect the G1 power window regulator master switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J1-5 (SU) - G1-18 (U) | Always | Below 1 Ω |
| J1-2 (SD) - G1-10 (D) | Always | Below 1 Ω |
| J1-5 (SU) - Body ground | Always | 10 kΩ or higher |
| J1-2 (SD) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||