LIGHTING SYSTEM > IG Signal Circuit |

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| IG SW | Ignition switch ON signal / OFF or ON | OFF: Ignition switch ACC or off ON: Ignition switch ON | - |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - BATTERY AND BODY GROUND) |
![]() |
for LHD
Disconnect the 3E and 3B instrument panel junction block assembly connectors.
for RHD
Disconnect the 3F and 3B instrument panel junction block assembly connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 3E-1 - Body ground | Always | 11 to 14 V |
| Tester Connection | Switch Condition | Specified Condition |
| 3F-1 - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3B-8 - Body ground | Always | Below 1 Ω |
| *A | for LHD |
| *B | for RHD |
| *a | Front view of wire harness connector (to Instrument Panel Junction Block Assembly) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - IGNITION SWITCH) |
![]() |
Reconnect the instrument panel junction block assembly connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 3A-29 - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Component with harness connected (Instrument Panel Junction Block Assembly) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY) |
Disconnect the 3A instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3A-40 - 3A-54 | Always | Below 1 Ω |
| 3A-40 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.REPLACE MAIN BODY ECU |
Replace the main body ECU (Click here).
| NEXT | |
| 6.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| IG SW | Ignition switch ON signal / OFF or ON | OFF: Ignition switch ACC or off ON: Ignition switch ON | - |
|
| ||||
| OK | ||
| ||