Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > Key-off Operation Function Operates even if Operating Conditions are not Satisfied

for Preparation Click here


DESCRIPTION

  1. When the front doors are closed, driver door power window regulator motor can control its power window operation for approximately 45 seconds after the ignition switch is turned from ON to off (the key is removed) by receiving operation permission signals from the main body ECU. However, when approximately 45 seconds have elapsed, or the driver door or front passenger door is opened within approximately 45 seconds of the ignition switch being turned off (the key is removed), the power window regulator motor stops operating.
    During AUTO function operation, the window operation will continue until complete even if 45 seconds have passed or a door is opened.

WIRING DIAGRAM


B291672E01


INSPECTION PROCEDURE

NOTICE:
The power window control system uses a LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (Click here). Troubleshoot the power window control system after confirming that the communication system is functioning properly.

1.CHECK OPERATION FUNCTION AFTER IGNITION SWITCH IS TURNED OFF
  1. Check the power window operation function after the ignition switch is turned off.

    Result 
    Result
    Proceed to
    When power window can still be operated even after opening driver door or front passenger door within approximately 45 seconds of ignition switch being turned off
    A
    When power window can still be operated even after approximately 45 seconds have elapsed after ignition switch turned off
    B



B
REPLACE MAIN BODY ECU (Click here)
A


2.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    FR Door Courtesy
    Front door courtesy light switch RH signal /
    ON or OFF
    ON: Front door RH closed
    OFF: Front door RH opened
    -
    FL Door Courtesy
    Front door courtesy light switch LH signal /
    ON or OFF
    ON: Front door LH closed
    OFF: Front door LH opened
    -

    OK:
    Normal conditions listed above are displayed.



NG
GO TO LIGHTING SYSTEM (Click here)
OK

REPLACE MAIN BODY ECU (Click here)