TRANSMISSION CONTROL CABLE > REMOVAL |
| 1. REMOVE REAR CONSOLE BOX ASSEMBLY |
| 2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
Move the shift lever to N.
![]() |
Disconnect the end of the transmission control cable assembly from the shift lever assembly.
![]() |
Rotate the nut counterclockwise approximately 180°, and while supporting the nut, separate the transmission control cable assembly from the shift lever retainer.
| *1 | Nut |
| 3. REMOVE BATTERY |
![]() |
Disconnect the cable from the battery terminal.
Loosen the 2 nuts and remove the battery clamp.
Remove the battery.
| 4. REMOVE BATTERY TRAY |
| 5. REMOVE BATTERY CARRIER (for LHD) |
![]() |
Disengage the 6 wire harness clamps and separate the wire harness from the battery carrier.
Remove the 5 bolts and the battery carrier.
| 6. REMOVE BATTERY CARRIER (for RHD) |
![]() |
Disengage the 7 wire harness clamps and separate the wire harness from the battery carrier.
Remove the 5 bolts and the battery carrier.
| 7. REMOVE AIR CLEANER ASSEMBLY |
![]() |
Disengage the clamp and disconnect the fuel vapor feed hose assembly from the No. 1 air cleaner hose.
Loosen the 2 hose clamps and disconnect the fuel vapor feed hose assembly from the No. 1 air cleaner hose and vacuum switching valve assembly.
![]() |
Disconnect the No. 2 fuel vapor feed hose from the intake manifold.
![]() |
Disengage the 2 clamps and disconnect the wire harness from the air cleaner cap sub-assembly and vacuum switching valve assembly.
Disconnect the mass air flow meter connector.
Disconnect the vacuum switching valve connector.
![]() |
Loosen the hose clamp and disconnect the No. 1 air cleaner hose from the throttle with motor body assembly.
Disengage the 2 clamps and remove the air cleaner cap sub-assembly with No. 1 air cleaner hose.
![]() |
Remove the air cleaner element.
![]() |
Disengage the clamp and disconnect the wire harness from the air cleaner case.
Remove the 2 bolts and the air cleaner case from the air cleaner bracket.
| 8. REMOVE AIR CLEANER BRACKET |
![]() |
Disengage the clamp and disconnect the wire harness from the air cleaner bracket.
Remove the 2 bolts and the air cleaner bracket.
| 9. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
| 10. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR |
![]() |
Remove the 2 bolts, nut and the front No. 1 floor heat insulator.
| 11. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Separate the transmission control cable assembly from the control cable support.
![]() |
Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.
Remove the clip and separate the transmission control cable assembly from the No. 1 transmission control cable bracket.
![]() |
Remove the 3 nuts and the transmission control cable assembly.