EXHAUST MANIFOLD > REMOVAL |
| 1. REMOVE HEATED OXYGEN SENSOR (for Sensor 1) |
| 2. REMOVE REAR CONSOLE BOX ASSEMBLY |
| 3. REMOVE FRONT FLOOR CENTER BRACE (w/ Side Mudguard) |
![]() |
Remove the 2 bolts and the front floor center brace from the body.
| 4. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
![]() |
Peel back the floor carpet.
![]() |
Disconnect the heated oxygen sensor connector.
Remove the oxygen sensor wire grommet and pass the connector through the hole to the outside of the vehicle.
![]() |
Remove the 2 bolts and 2 compression springs from the exhaust manifold.
![]() |
Remove the 2 bolts and 2 compression springs from the tail exhaust pipe assembly.
Remove the 3 exhaust pipe supports and the front exhaust pipe assembly.
| 5. REMOVE EXHAUST PIPE GASKET |
Remove the exhaust pipe gasket from the exhaust manifold.
| 6. REMOVE NO. 2 EXHAUST PIPE GASKET |
Remove the No. 2 exhaust pipe gasket from the front exhaust pipe assembly.
| 7. SEPARATE ENGINE MOVING CONTROL ROD |
![]() |
Remove the bolt and the engine moving control rod.
| 8. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR |
![]() |
Disengage the 2 wire harness clamps and separate the engine wire harness.
Remove the bolt and the wire harness bracket.
![]() |
Remove the 4 bolts and the No. 1 exhaust manifold heat insulator.
| 9. REMOVE MANIFOLD SUPPORT BRACKET |
![]() |
Remove the 3 bolts and the manifold support bracket.
| 10. REMOVE EXHAUST MANIFOLD |
![]() |
Remove the 3 bolts, 2 nuts and the exhaust manifold.
Remove the gasket from the cylinder head assembly.