Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Front Fog Light Circuit

for Preparation Click here


DESCRIPTION

The main body ECU controls the FR FOG relay.

WIRING DIAGRAM


E231528E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Active Test.

  1. According to the display on the intelligent tester, perform the Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Front Fog Light Relay
    Front Fog light relay
    OFF or ON
    Light Control switch is in TAIL or HEAD position

    OK:
    FOG FR relay operates. (Fog lights illuminate.)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.REPLACE MAIN BODY ECU
  1. Replace the main body ECU (Click here).


NEXT


3.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Active Test.

  1. According to the display on the intelligent tester, perform the Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Front Fog Light Relay
    Front Fog light relay
    OFF or ON
    Light Control switch is in TAIL or HEAD position

    OK:
    FOG FR relay operates. (Fog lights illuminate.)



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
OK

END (MAIN BODY ECU WAS DEFECTIVE)