Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side as for the LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY
(Click here)


2. REMOVE FRONT NO. 1 VENTILATOR SEAL


C242062
  1. Disengage the clamp and remove the front No. 1 ventilator seal.



3. REMOVE FRONT AIR SHUTTER SEAL RH

HINT:
Use the same procedure as for the No. 1 ventilator seal.



4. REMOVE INNER COWL TOP TO COWL BRACE


C242063
  1. Remove the 2 bolts and the inner cowl top to cowl brace.



5. REMOVE OUTER COWL TOP PANEL


C242064
  1. Disengage the 2 clamps and separate the wire harness.



  1. Remove the 8 bolts and the outer cowl top panel.


    C242065



6. REMOVE FRONT WHEEL


7. SEPARATE FRONT STABILIZER LINK ASSEMBLY


    C235026
  1. Remove the nut and separate the front stabilizer link assembly from the shock absorber.

    HINT:
    Using a socket hexagon wrench 6 to hold the stud.



8. SEPARATE FRONT FLEXIBLE HOSE (w/ ABS)


    C107502
  1. Remove the bolt and separate the front speed sensor and front flexible hose.



9. SEPARATE FRONT FLEXIBLE HOSE (w/o ABS)
  1. Remove the bolt and separate the front flexible hose.



10. REMOVE FRONT SUSPENSION SUPPORT DUST COVER


11. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING


    C107503
  1. Remove the 2 nuts and 2 bolts and separate the front shock absorber with coil spring from the steering knuckle.

    HINT:
    Keep the bolt from rotating while loosening and removing the nuts.



    C235027
  1. Using a socket hexagon wrench 6, fix the front shock absorber rod and remove the nut.

  1. Remove the front No. 2 suspension support.

  1. Remove the front shock absorber with coil spring from the vehicle.



12. REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY


13. REMOVE FRONT COIL SPRING UPPER SEAT


    C107505
  1. Using a socket hexagon wrench 6, fix the shock absorber rod and loosen the nut.



    C107506E03
  1. Using SST, compress the front coil spring.

    SST
    09727-30021   (09727-00010, 09727-00021, 09727-00031)

    NOTICE:
    Do not use an impact wrench. It will damage SST.

  1. Remove the nut.

  1. Remove the front coil spring upper seat with the strut mounting bearing and front spring bumper from the front shock absorber.



14. REMOVE FRONT SPRING BUMPER
  1. Remove the front spring bumper from the front coil spring upper seat.



15. REMOVE FRONT COIL SPRING UPPER INSULATOR


16. REMOVE FRONT COIL SPRING


17. REMOVE STRUT MOUNTING BEARING


    C235443
  1. Using a brass bar and press, remove the strut mounting bearing from the front coil spring upper seat.