Home › Drivetrain ยท CLUTCH › CLUTCH PEDAL (for LHD)

CLUTCH PEDAL (for LHD) > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B284272
  1. Remove the 2 <A> screws.

  1. Disengage the claw and the guide and remove the instrument panel under cover.



2. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL


    B284273
  1. Disengage the 5 clips and the 2 claws and remove the instrument panel finish panel.



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL


  1. for LHD:



      B284274
    1. Disengage the 2 clips and the 5 claws and remove the instrument panel finish panel.



  1. for RHD:



      B272572
    1. Disengage the 2 clips and the 6 claws and remove the instrument panel finish panel.



4. REMOVE COMBINATION METER ASSEMBLY
(Click here)


5. REMOVE CLUTCH PEDAL SUPPORT SUB-ASSEMBLY
  1. Disconnect the connector and disengage the wire harness clamp.



    C247292
  1. Push the clutch master cylinder push rod clevis upward and release it toward the left side of the vehicle.



    C247288
  1. Remove the bolt, the 2 nuts and the clutch pedal support sub-assembly.



6. REMOVE CLUTCH START SWITCH ASSEMBLY


    C187734
  1. Remove the nut and the clutch start switch assembly from the clutch pedal support sub-assembly.



7. REMOVE CLUTCH PEDAL STOPPER BOLT


    C245186
  1. Loosen the lock nut and remove the clutch pedal stopper bolt from the clutch pedal support sub-assembly.



8. REMOVE CLUTCH PEDAL SPRING


    C242404
  1. Remove the clutch pedal spring.



9. REMOVE CLUTCH PEDAL SUB-ASSEMBLY


    C247289
  1. Remove the bolt, the nut and the clutch pedal sub-assembly from the clutch pedal support sub-assembly.

    NOTICE:
    Turn the nut while holding the bolt.



10. REMOVE CLUTCH PEDAL SHAFT COLLAR


    C242405
  1. Remove the 2 clutch pedal bushes and the clutch pedal shaft collar from the clutch pedal sub-assembly.



11. REMOVE NO. 1 CLUTCH PEDAL CUSHION


    C245185E01
  1. Remove the No. 1 clutch pedal cushion from the clutch pedal sub-assembly.
    Text in Illustration 
    *A
    for 1NZ-FE
    *B
    for 2NZ-FE



12. REMOVE CLUTCH PEDAL PAD
  1. Remove the clutch pedal pad from the clutch pedal sub-assembly.