Home › Drivetrain ยท CLUTCH › CLUTCH MASTER CYLINDER (for LHD)

CLUTCH MASTER CYLINDER (for LHD) > REMOVAL

for Preparation Click here



1. REMOVE BRAKE BOOSTER ASSEMBLY
(Click here)


2. REMOVE CLUTCH RESERVOIR TUBE


    C242416
  1. Slide the clip and remove the clutch reservoir tube from the clutch master cylinder assembly.

    HINT:
    Use a container to collect the fluid.



3. DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE


    C115313
  1. Using a union nut wrench (10 mm), disconnect the clutch master cylinder to flexible hose tube from the clutch master cylinder assembly.

    HINT:
    Use a container to collect the fluid.



4. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY


    C247292
  1. Push the clutch master cylinder push rod clevis upward and release it toward the left side of the vehicle.



    C203768
  1. Remove the 2 nuts and the clutch master cylinder assembly.



5. REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS


    C247297E01
  1. Measure the dimension A as shown in the illustration before loosening the lock nut.
    Text in Illustration 
    *1
    Lock Nut
    *2
    Clutch Master Cylinder Push Rod Clevis

  1. Loosen the lock nut and remove the clutch master cylinder push rod clevis from the push rod.

    NOTICE:
    When loosening the lock nut, be sure to hold the clevis in place by its square portion.

  1. Remove the lock nut from the push rod.