Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)

DTC    B1620/21    Side Airbag Sensor RH Circuit Malfunction

DTC    B1622/81    Lost communication with Side Airbag Sensor RH

for Preparation Click here


DESCRIPTION

The side collision sensor RH circuit (to determine deployment of the front seat side airbag assembly RH and curtain shield airbag assembly RH) is composed of the airbag sensor assembly, side airbag sensor assembly RH and No. 2 side airbag sensor assembly RH.
The side airbag sensor assembly RH detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the airbag should be deployed. DTC B1620/21 or B1622/81 is stored when a malfunction is detected in the side collision sensor RH circuit.

DTC No.
DTC Detection Condition
Trouble Area
B1620/21
B1622/81
  1. Side airbag sensor assembly RH malfunction
  2. Airbag sensor assembly malfunction
  1. Side airbag sensor assembly RH
  2. Airbag sensor assembly

WIRING DIAGRAM


C241675E09


INSPECTION PROCEDURE

1.CHECK SIDE AIRBAG SENSOR ASSEMBLY RH
C235513E01
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Interchange the side airbag sensor assembly RH with the side airbag sensor assembly LH and connect the connectors to them.

  1. Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Clear the DTCs stored in the memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B1620/21, B1622/81, B1625/22 and B1627/82 are not output.
    A
    DTC B1625/22 or B1627/82 is output.
    B
    DTC B1620/21 or B1622/81 is output.
    C
    Text in Illustration 
    *1
    Side Airbag Sensor Assembly LH
    *2
    Airbag Sensor Assembly

    HINT:
    DTCs other than B1620/21, B1622/81, B1625/22 and B1627/82 may be output at this time, but they are not related to this check.

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Return the side airbag sensor assembly RH and the side airbag sensor assembly LH to their original positions and connect the connectors to them.



B
REPLACE SIDE AIRBAG SENSOR ASSEMBLY RH (Click here)

C
REPLACE AIRBAG SENSOR ASSEMBLY (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)