Home › Drivetrain ยท CLUTCH › CLUTCH PEDAL (for RHD)

CLUTCH PEDAL (for RHD) > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

HINT:
Use the same procedure as for LHD models .



2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)


  1. for LHD:



      B284274
    1. Disengage the 2 clips and the 5 claws and remove the instrument panel finish panel.



  1. for RHD:



      B272572
    1. Disengage the 2 clips and the 6 claws and remove the instrument panel finish panel.



3. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

HINT:
Use the same procedure as for LHD models (Click here).



4. REMOVE CLUTCH PEDAL SUPPORT SUB-ASSEMBLY
  1. Disconnect the connectors and disengage the wire harness clamps.



    C235126
  1. Remove the clip and the clevis pin, and separate the clutch master cylinder push rod clevis from the clutch pedal sub-assembly.



    C235127
  1. Remove the 2 nuts and separate the clutch master cylinder assembly from the clutch pedal support sub-assembly.



    C235123
  1. Remove the 2 bolts and the clutch pedal support sub-assembly.



5. REMOVE CLUTCH START SWITCH ASSEMBLY


    C235128
  1. Remove the nut and the clutch start switch assembly from the clutch pedal support sub-assembly.



6. REMOVE NO. 2 CLUTCH START SWITCH ASSEMBLY (w/ Cruise Control System)


    C242413
  1. Remove the nut and the No. 2 clutch start switch assembly from the clutch pedal support sub-assembly.



7. REMOVE CLUTCH PEDAL STOPPER BOLT


    C235129
  1. Loosen the lock nut and remove the clutch pedal stopper bolt from the clutch pedal support sub-assembly.



8. REMOVE CLUTCH PEDAL SPRING


    C242423
  1. Remove the clutch pedal spring.



9. REMOVE CLUTCH PEDAL SUB-ASSEMBLY


    C235130
  1. Remove the bolt, the nut and the clutch pedal sub-assembly from the clutch pedal support sub-assembly.

    NOTICE:
    Turn the nut while holding the bolt.



10. REMOVE CLUTCH PEDAL SHAFT COLLAR


    C235131
  1. Remove the 2 clutch pedal bushes and the clutch pedal shaft collar from the clutch pedal sub-assembly.



11. REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS BUSH


    C235133
  1. Using a hexagon wrench (8 mm) and a hammer, remove the clutch master cylinder push rod clevis bush from the clutch pedal sub-assembly.



12. REMOVE NO. 1 CLUTCH PEDAL CUSHION
  1. Remove the No. 1 clutch pedal cushion from the clutch pedal sub-assembly.



13. REMOVE CLUTCH PEDAL STOPPER
  1. Remove the clutch pedal stopper from the clutch pedal sub-assembly.



14. REMOVE CLUTCH PEDAL PAD
  1. Remove the clutch pedal pad from the clutch pedal sub-assembly.