FRONT AXLE HUB > REMOVAL |
| 1. REMOVE FRONT WHEEL |
| 2. REMOVE FRONT AXLE SHAFT NUT |
![]() |
Using SST and a hammer, release the staked part of the front axle shaft nut.
Using a deep socket wrench 30 mm, remove the front axle shaft nut.
| 3. SEPARATE FRONT SPEED SENSOR (w/ ABS) |
![]() |
Remove the bolt and separate the speed sensor and flexible hose.
![]() |
Remove the bolt and separate the speed sensor from the steering knuckle.
| 4. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY |
![]() |
Remove the 2 bolts and separate the disc brake caliper assembly.
| 5. REMOVE FRONT DISC |
![]() |
Place matchmarks on the disc and axle hub and remove the disc.
| *a | Matchmark |
| 6. SEPARATE TIE ROD END SUB-ASSEMBLY |
Remove the cotter pin and castle nut.
![]() |
Install SST to the threaded section of the tie rod end.
Using SST, separate the tie rod end from the front axle assembly.

| *a | Place the wrench here | - | - |
![]() | Apply grease to the bolt threads and the tip of SST. | - | - |
| 7. SEPARATE FRONT LOWER SUSPENSION ARM |
Remove the clip and castle nut.
![]() |
Install SST to the threaded section of the lower ball joint.
Using SST, separate the lower arm.

| *a | Place the wrench here | - | - |
![]() | Apply grease to the bolt threads and the tip of SST. | - | - |
| 8. SEPARATE FRONT STABILIZER LINK ASSEMBLY |
![]() |
Remove the nut and separate the front stabilizer link assembly from the shock absorber.
| 9. REMOVE FRONT AXLE ASSEMBLY |
Using a plastic hammer, tap the end of the drive shaft and separate the fitting between the drive shaft and front axle hub.
![]() |
Remove the 2 nuts, 2 bolts and the front axle assembly.
| 10. REMOVE FRONT AXLE HUB HOLE SNAP RING |
![]() |
Using snap ring pliers, remove the axle hub hole snap ring.
| *1 | Snap Ring Pliers |
| 11. REMOVE FRONT AXLE HUB SUB-ASSEMBLY |
![]() |
Fix the steering knuckle in a vise between aluminum plates.
Using SST, remove the axle hub.
![]() |
Using SST, remove the axle hub bearing inner race.
| *a | Hold |
| *b | Turn |
| 12. REMOVE FRONT AXLE HUB BEARING |