STEERING KNUCKLE > REMOVAL |
| 1. REMOVE FRONT AXLE ASSEMBLY |
| 2. REMOVE FRONT AXLE HUB HOLE SNAP RING |
![]() |
Using snap ring pliers, remove the axle hub hole snap ring.
| *1 | Snap Ring Pliers |
| 3. REMOVE FRONT AXLE HUB SUB-ASSEMBLY |
![]() |
Fix the steering knuckle in a vise between aluminum plates.
Using SST, remove the axle hub.
![]() |
Using SST, remove the axle hub bearing inner race.
| *a | Hold |
| *b | Turn |
| 4. REMOVE FRONT DISC BRAKE DUST COVER |
![]() |
Remove the disc brake dust cover by tapping the back side with a brass bar and hammer.
| 5. REMOVE FRONT AXLE HUB BEARING |
![]() |
Install the removed axle hub bearing inner race onto the outer side of the axle hub bearing.
Using SST and a press, remove the axle hub bearing.