DTC C146C Open in ABS Motor Relay Circuit |
DTC C146D Short in ABS Motor Relay Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C146C | When either of the following is detected:
|
|
| C146D | When the motor relay is OFF, the motor relay remains closed for 4 seconds or more. |
|

| 1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (ABS MOTOR RELAY) |
Connect the intelligent tester to the DLC3.
Start the engine.
Turn the tester on.
Clear the DTC (Click here).
Enter the following menu: Chassis / ABS/VSC/TRC / Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Motor Relay | ABS motor relay | Relay ON / OFF | Operating sound of motor can be heard. |
Check the operating sound of the ABS motor relay when operating it with the intelligent tester.
| Result | Proceed to |
| The operating sound is not heard | A |
| The operating sound is heard | B |
|
| ||||
| A | |
| 2.CHECK TERMINAL VOLTAGE (+BM TERMINAL) |
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
Check the connector case and terminals for deformation and corrosion.
![]() |
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A55-24 (+BM) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Skid control ECU) |
Turn the ignition switch off.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (GND2 TERMINAL) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A55-13 (GND2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Skid control ECU) |
|
| ||||
| OK | |
| 4.RECONFIRM DTC |
Clear the DTC (Click here).
Start the engine.
Drive the vehicle at the speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output (for LHD) | B |
| DTC is output (for RHD) | C |
|
| ||||
|
| ||||
| A | ||
| ||