Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER (for RHD)

BRAKE BOOSTER (for RHD) > INSTALLATION

for Preparation Click here



1. INSTALL BRAKE BOOSTER ASSEMBLY
  1. Install a new gasket onto the brake booster assembly.

  1. Temporary install the brake booster assembly with the 4 nuts.



    C233126E01
  1. Tighten the 4 nuts as shown in the illustration.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Install the wire harness clamp.

  1. Connect the vacuum hose to the vacuum check valve with the clip.



2. INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS
  1. Install the push rod lock nut and brake master cylinder push rod clevis to the brake booster assembly.

    HINT:
    Tighten the push rod lock nut after adjusting the brake pedal height.



    C235059E01
  1. Apply lithium soap base glycol grease to the push rod pin.
    Text in Illustration 
    *1
    Lithium Soap Base Glycol Grease

  1. Install the brake master cylinder push rod clevis with the push rod pin and a new clip.

  1. Install the brake pedal return spring.



3. INSTALL OUTER COWL TOP PANEL
  1. Install the outer cowl top panel with the 8 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Engage the 2 clamps and install the wire harness.



4. INSTALL INNER COWL TOP TO COWL BRACE
  1. Install the cowl top to cowl brace with the 2 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



5. INSTALL FRONT NO. 1 VENTILATOR SEAL
  1. Engage the clip and install the front No. 1 ventilator seal.



6. INSTALL FRONT AIR SHUTTER SEAL RH

HINT:
Use the same procedure as for the front No. 1 ventilator seal.



7. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
(Click here)


8. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY
(Click here)


9. INSPECT AND ADJUST BRAKE PEDAL
(Click here)


10. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)
  1. for LHD:

    1. Engage the 5 claws and 2 clips and install the instrument panel finish panel.

  1. for RHD:

    1. Engage the 6 claws and 2 clips and install the instrument panel finish panel.



11. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
(Click here)


12. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Engage the guide and the claw.

  1. Install the instrument panel under cover with the 2 <A> screws.