Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Taillight Relay Circuit

for Preparation Click here


DESCRIPTION

The main body ECU controls the TAIL relay.

WIRING DIAGRAM


E229433E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Active Test.

  1. According to the display on the intelligent tester, perform the Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Taillight Relay
    Taillight relay
    OFF or ON
    -

    OK:
    TAIL relay operates. (Clearance lights, taillights and license plate lights illuminate.)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - BATTERY)
E219683E01
  1. for LHD

    1. Disconnect the 3E instrument panel junction block assembly connectors.

  1. for RHD

    1. Disconnect the 3F instrument panel junction block assembly connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    for LHD 
    Tester Connection
    Condition
    Specified Condition
    3E-1 - Body ground
    Always
    11 to 14 V
    for RHD 
    Tester Connection
    Condition
    Specified Condition
    3F-1 - Body ground
    Always
    11 to 14 V

    Text in Illustration 
    *A
    for LHD
    *B
    for RHD
    *a
    Front view of wire harness connector
    (to Instrument Panel Junction Block Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE MAIN BODY ECU
  1. Replace the main body ECU (Click here).


NEXT


4.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Active Test.

  1. According to the display on the intelligent tester, perform the Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Taillight Relay
    Taillight relay
    OFF or ON
    -

    OK:
    TAIL relay operates. (Clearance lights, taillights and license plate lights illuminate.)



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
OK

END (MAIN BODY ECU WAS DEFECTIVE)