CAN COMMUNICATION SYSTEM (for Separate Type Yaw Rate Sensor) > Combination Meter ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Combination Meter ECU Communication Stop Mode | Either condition is met:
|
|

| 1.CHECK OPEN IN CAN BUS WIRE (COMBINATION METER ASSEMBLY MAIN WIRE) |
![]() |
Disconnect the F1 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| F1-32 (CANH) - F1-31 (CANL) | Ignition switch off | 108 to 132 Ω |
| *a | Front view of wire harness connector (to Combination Meter Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| F1-39 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| F1-40 (B) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F1-14 (-) - Body ground | Always | Below 1 Ω |
| F1-21 (ET) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Combination Meter Assembly) |
|
| ||||
| OK | ||
| ||