Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM (w/ VSC/Separate Type Yaw Rate Sensor)

DTC    B1635/24    Rear Airbag Sensor LH Circuit Malfunction

for Preparation Click here


DESCRIPTION

The No. 2 side airbag sensor assembly LH consists of the safing sensor, the diagnostic circuit, the lateral deceleration sensor, etc.
If the airbag sensor assembly receives signals from the lateral deceleration sensor, it determines whether the SRS should be activated.
DTC B1635/24 is recorded when a malfunction is detected in the No. 2 side airbag sensor assembly LH circuit.

DTC No.
DTC Detection Condition
Trouble Area
B1635/24
When one of following conditions is met:
  1. No. 2 side airbag sensor assembly LH malfunction
  2. Airbag sensor assembly malfunction
  1. No. 2 side airbag sensor assembly LH
  2. Airbag sensor assembly

WIRING DIAGRAM


C241048E17


C241675E17


INSPECTION PROCEDURE

1.CHECK NO.2 SIDE AIRBAG SENSOR ASSEMBLY LH
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



    C251237E01
  1. Interchange the No. 2 side airbag sensor assembly LH with No. 2 side airbag sensor assembly RH and connect the connectors to them.
    Text in Illustration 
    *A
    for 3 Door
    *B
    for 5 Door
    *1
    No. 2 Side Airbag Sensor Assembly RH
    *2
    Airbag Sensor Assembly
    *3
    Side Airbag Sensor Assembly LH

  1. Connect the cable to the negative battery terminal, and wait for at least 2 seconds.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Clear the DTCs stored in the memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON, and wait for at least 60 seconds.

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B1630/23 and B1635/24 are not output
    A
    DTC B1630/23 is output (for 3 Door)
    B
    DTC B1630/23 is output (for 5 Door)
    C
    DTC B1635/24 is output
    D

    HINT:
    DTCs other than B1630/23 and B1635/24 may be output at this time, but they are not related to this check.

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  1. Return the No. 2 side airbag sensor assembly LH and the No. 2 side airbag sensor assembly RH to their original positions and connect the connectors to them.



B
REPLACE NO.2 SIDE AIRBAG SENSOR ASSEMBLY LH (Click here)

C
REPLACE NO.2 SIDE AIRBAG SENSOR ASSEMBLY LH (Click here)

D
REPLACE AIRBAG SENSOR ASSEMBLY (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)