Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND DECELERATION SENSOR

YAW RATE AND DECELERATION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL YAW RATE AND DECELERATION SENSOR
  1. Install the yaw rate and deceleration sensor with the 2 nuts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    Make sure that the sensor is at the correct angle when installing.

  1. Connect the yaw rate and deceleration sensor connector.



2. INSTALL YAW RATE SENSOR PROTECTOR
  1. Install the yaw rate sensor protector with the 2 nuts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }



3. INSTALL REAR CONSOLE BOX ASSEMBLY
(Click here)


4. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
(Click here)