Home › Engine / Hybrid System ยท 1NZ-FE › ENGINE CONTROL › HEATED OXYGEN SENSOR (for Sensor 1)

HEATED OXYGEN SENSOR (for Sensor 1) > REMOVAL

for Preparation Click here



1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
(Click here)


2. REMOVE FRONT NO. 1 VENTILATOR SEAL (for LHD)


C242062
  1. Disengage the clamp and remove the front No. 1 ventilator seal.



3. REMOVE FRONT NO. 1 VENTILATOR SEAL (for RHD)


A249556
  1. Disengage the clamp and remove the front No. 1 ventilator seal.



4. REMOVE FRONT AIR SHUTTER SEAL RH (for LHD)

HINT:
Use the same procedure as for the No. 1 ventilator seal.



5. REMOVE FRONT AIR SHUTTER SEAL RH (for RHD)

HINT:
Use the same procedure as for the No. 1 ventilator seal.



6. REMOVE INNER COWL TOP TO COWL BRACE (for LHD)


C242063
  1. Remove the 2 bolts and the inner cowl top to cowl brace.



7. REMOVE INNER COWL TOP TO COWL BRACE (for RHD)


A249554
  1. Remove the 2 bolts and the inner cowl top to cowl brace.



8. REMOVE OUTER COWL TOP PANEL (for LHD)


C242064
  1. Disengage the 2 clamps and separate the wire harness.



  1. Remove the 8 bolts and the outer cowl top panel.


    C242065



9. REMOVE OUTER COWL TOP PANEL (for RHD)


A249552
  1. Disengage the 2 clamps and separate the wire harness.



  1. Remove the 8 bolts and the outer cowl top panel.


    A249553



10. REMOVE HEATED OXYGEN SENSOR (for Sensor 1)


    A251039
  1. Disconnect the heated oxygen sensor connector.

  1. Separate the wire harness from the wire harness bracket.



    A143237E05
  1. Using SST, remove the heated oxygen sensor.

    SST
    09224-00010  

    NOTICE:
    Do not damage the heated oxygen sensor.