Home › Power Source / Network · NETWORKING › LIN COMMUNICATION SYSTEM

LIN COMMUNICATION SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

E217205E01


Text in Illustration 
*A
for LHD
*B
for RHD
*a
Component without harness connected
(Instrument Panel Junction Block Assembly)
*b
Component without harness connected
(Main Body ECU (Multiplex Network Body ECU))
  1. Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly (Click here).

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Switch Condition
    Specified Condition
    MB-11 (GND1) - Body ground
    None - Body ground
    Ground
    Always
    Below 1 Ω
    MB-29 (ACC) - Body ground
    None - Body ground
    Battery power supply
    Ignition switch ACC
    11 to 14 V
    MB-30 (BECU) - Body ground
    None - Body ground
    Battery power supply
    Always
    11 to 14 V
    MB-32 (IG) - Body ground
    None - Body ground
    Battery power supply
    Ignition switch ON
    11 to 14 V
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Install the main body ECU (multiplex network body ECU) onto the instrument panel junction block assembly.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Switch Condition
    Specified Condition
    3B-12(LIN2) - 3B-8 (GND1)
    W - W-B
    LIN Communication line
    Ignition switch ON
    Pulse generation
    If the result is not as specified, the main body ECU (multiplex network body ECU) or instrument panel junction block assembly may have a malfunction.


CHECK POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (for Driver Side) (for LHD)

E200943E06

  1. Disconnect the H3 power window regulator motor assembly LH (for driver side) connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    H3-1 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    H3-2 (B) - Body ground
    G - Body ground
    Battery power supply
    Always
    11 to 14 V
    If the result is not as specified, there may be a malfunction in the wire harness.


CHECK POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (for Driver Side) (for RHD)

E200943E05

  1. Disconnect the G3 power window regulator motor assembly RH (for driver side) connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    G3-1 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    G3-2 (B) - Body ground
    G - Body ground
    Battery power supply
    Always
    11 to 14 V
    If the result is not as specified, there may be a malfunction in the wire harness.