Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)

AIR CONDITIONING SYSTEM (for Manual Air Conditioning System) > Heater Control Switch Circuit

for Preparation Click here


DESCRIPTION

The No. 1 heater control sub-assembly (A/C switch, A/C LED) is powered through the A/C fuse. The No. 1 heater control sub-assembly (A/C switch, A/C LED) transmits operational signals of each switch to the air conditioning amplifier assembly.

WIRING DIAGRAM


E227904E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.INSPECT NO. 1 HEATER CONTROL SUB-ASSEMBLY (A/C SWITCH, A/C LED)
  1. Inspect the No. 1 heater control sub-assembly (A/C switch, A/C LED) (Click here).



NG
REPLACE NO. 1 HEATER CONTROL SUB-ASSEMBLY (A/C SWITCH, A/C LED) (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (NO. 1 HEATER CONTROL SUB-ASSEMBLY (A/C SWITCH, A/C LED) - IG1 NO. 1 RELAY)


    E225968E01
  1. Disconnect the F38 No. 1 heater control sub-assembly (A/C switch, A/C LED) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F38-2 (L) - Body ground
    Ignition switch off
    Below 1 V
    F38-2 (L) - Body ground
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to No. 1 Heater Control Sub-Assembly (A/C Switch, A/C LED))



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (NO. 1 HEATER CONTROL SUB-ASSEMBLY (A/C SWITCH, A/C LED) - AIR CONDITIONING AMPLIFIER ASSEMBLY)
  1. Disconnect the F38 No. 1 heater control sub-assembly (A/C switch, A/C LED) connector.

  1. Disconnect the F41 air conditioning amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F38-3 (E) - F41-16 (LED)
    Always
    Below 1 Ω
    F38-4 (B) - F41-2 (A/C)
    Always
    Below 1 Ω
    F38-3 (E) - Body ground
    Always
    10 kΩ or higher
    F38-4 (B) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)