DTC P0500 Vehicle Speed Sensor "A" |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0500 | While vehicle is being driven, no vehicle speed sensor signal is sent to the ECM. (1 trip detection logic: automatic transaxle) (2 trip detection logic: manual transaxle) |
|
| Required Sensors/Components (Main) | Vehicle speed sensor, Combination meter and Skid control ECU |
| Required Sensors/Components (Related) | Park/neutral position switch assembly, Engine coolant temperature sensor, Throttle with motor body assembly and Mass air flow meter |
| Frequency of Operation | Continuous |
| Ignition Switch | ON |
| Time after ignition switch OFF to ON | 3 seconds or more |
| Battery voltage | 11 V or higher |
| Starter | OFF |
| Time after PNP switch turned off | 30 seconds |
| Time after ignition switch turned from OFF to ON | 3 seconds or more |
| Ignition switch | ON |
| Starter | OFF |
| Fuel-cut | ON |
| Vehicle speed sensor signal | No pulse input |

| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Vehicle Speed.
Drive the vehicle.
Read the value displayed on the tester.
| Result | Proceed to |
| Values displayed on tester and speedometer display not equal | A |
| Values displayed on tester and speedometer display equal | B |
|
| ||||
| A | |
| 2.CHECK COMBINATION METER SYSTEM |
Check the circuits that send vehicle speed signals to this system in the meter system (Click here).
| NEXT | |
| 3.CHECK WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Clear DTCs (even if no DTCs are stored, perform the clear DTC operation).
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON and turn the tester on.
Start the engine and warm it up.
Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine and ECT / DTC.
| NEXT | ||
| ||