Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the combination meter.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK CAN COMMUNICATION SYSTEM*
    1. Use an intelligent tester to check if the CAN communication system is functioning normally.

      1. except Separate Type Yaw Rate Sensor (Click here)
      1. for Separate Type Yaw Rate Sensor (Click here)
      Result 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output (except Separate Type Yaw Rate Sensor)
      B
      CAN DTC is output (for Separate Type Yaw Rate Sensor)
      C



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)

    C.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    4.PROBLEM SYMPTOMS TABLE
      Result 
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B


    B.
    Go to step 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Data List/Active Test (Click here).

    2. Terminals of ECU (Click here).

    3. On-vehicle Inspection (Click here).


    NEXT


    6.ADJUST, REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST*

        NEXT

        END