RADIO ANTENNA CORD > REMOVAL |
| 1. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY |
| 2. REMOVE STEREO OPENING COVER WITH BRACKET (w/o Radio Receiver) |
![]() |
Remove the 4 screws and the stereo opening cover with bracket.
| 3. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (w/ Radio Receiver) |
![]() |
Remove the 4 screws.
Disengage the 4 clips.
Disconnect the connectors and remove the radio receiver assembly with bracket.
| 4. REMOVE ANTENNA CORD SUB-ASSEMBLY |
![]() |
Disconnect the connector.
Remove the bolt.
Using a clip remover, disengage the 3 clamps.
![]() |
Using a clip remover, disengage the 2 clamps and remove the antenna cord.
| 5. REMOVE ROOF HEADLINING ASSEMBLY (for 5 Door) |
| 6. REMOVE ROOF HEADLINING ASSEMBLY (for 3 Door) |
| 7. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY |
Remove the 12 pieces of tape.

Remove the antenna cord from the clamp of the rear side rail spacer.