DTC C1442 Invalid Data Received from Acceleration Sensor |
DTC C1443 Invalid Data Received from Yaw Rate Sensor |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1442 | Both of the following is condition is met.
| Yaw rate and deceleration (yaw rate sensor) |
| C1443 | Both of the following is condition is met.
|
| 1.CHECK DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine and idle it for 60 seconds, and then stop the engine.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTCs C1442 and/or C1443 are output | A |
| DTCs C1442 and C1443 are not output | B |
|
| ||||
| A | ||
| ||