CONDENSER > INSTALLATION |
| 1. INSTALL COOLER CONDENSER ASSEMBLY |
Engage the 2 claws, 2 guides and install the cooler condenser into the vehicle.
| 2. CONNECT LIQUID TUBE SUB-ASSEMBLY A (w/o Fan Shroud Ventilation Duct) |
Remove the attached vinyl tape from the tube and the connecting part of the cooler condenser.
Apply sufficient compressor oil to a new O-ring and the fitting surface of the tube joint.
Install the O-ring onto the liquid tube.
Install the liquid tube onto the cooler condenser with the bolt.
| 3. CONNECT LIQUID TUBE SUB-ASSEMBLY B (w/ Fan Shroud Ventilation Duct) |
Remove the attached vinyl tape from the tube and the connecting part of the cooler condenser.
Apply sufficient compressor oil to a new O-ring and the fitting surface of the tube joint.
Install the O-ring onto the liquid tube.
Install the liquid tube onto the cooler condenser with the 2 bolts.
| 4. INSTALL AIR DUCT (w/ Fan Shroud Ventilation Duct) |
Engage the 4 claws and install the fan shroud ventilation duct.
| 5. CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser.
Apply sufficient compressor oil to a new O-ring and the fitting surface of the hose joint.
Install the O-ring onto the discharge hose.
Install the discharge hose onto the cooler condenser with the bolt.
| 6. INSTALL NO. 1 COOLER COVER |
Engage the 2 guides and install the cooler cover.
| 7. INSTALL RADIATOR UPPER SUPPORT SUB-ASSEMBLY |
Install the radiator upper support with the 4 bolts.
Engage the 2 clamps and install the hood lock control cable.
Engage the 2 clamps and install the wire harness.
Connect the connector.
Install the 2 clips.
| 8. INSTALL FRONT AIRBAG SENSOR |
| 9. INSTALL HEADLIGHT ASSEMBLY LH |
| 10. INSTALL HEADLIGHT ASSEMBLY RH |
| 11. CHARGE REFRIGERANT |

Perform vacuum purging using a vacuum pump.
Charge refrigerant HFC-134a (R134a).
| Item | Refrigerant Charging Amount |
| w/o Fan Shroud Ventilation Duct | 330 to 390 g (11.6 to 13.8 oz.) |
| w/ Fan Shroud Ventilation Duct | 350 to 410 g (12.3 to 14.5 oz.) |

Install the caps onto the service valves on the refrigerant line.
| 12. WARM UP ENGINE |
| 13. INSPECT FOR REFRIGERANT LEAK |
After recharging the refrigerant gas, check for refrigerant gas leakage using a halogen leak detector.
Perform the operation as follows:
![]() |
Using the halogen leak detector, check the refrigerant line, especially at the connection points, for leakage.
| *1 | Halogen Leak Detector |
![]() |
Bring the halogen leak detector close to the drain hose before performing the test.
| *1 | Drain Hose |
| *2 | Halogen Leak Detector |
If no gas leakage is detected from the drain hose, remove the blower motor from the cooling unit. Insert the halogen leak detector sensor into the unit and perform the test.
Disconnect the pressure switch connector and leave it for approximately 20 minutes. Bring the halogen leak detector close to the pressure switch and perform the test.