Home › Engine / Hybrid System · CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Clutch Switch Circuit

for Preparation Click here


DESCRIPTION

While depressing the clutch pedal, the clutch switch sends a signal to terminal 56 (D) of the ECM. The ECM cancels cruise control when terminal 56 (D) receives the signal.

WIRING DIAGRAM


B283123E03


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.INSPECT NO.2 CLUTCH START SWITCH ASSEMBLY
  1. Inspect the no. 2 clutch start switch assembly (Click here).



NG
REPLACE CLUTCH SWITCH ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (NO. 2 CLUTCH START SWITCH ASSEMBLY - ECM AND BATTERY)
  1. Disconnect the A41 no. 2 clutch start switch assembly connector.

  1. Disconnect the B84 ECM connector.



    B289452E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A41-1 - Body ground
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to No.2 Clutch Start Switch Assembly)

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A41-2 - B84-56 (D)
    Always
    Below 1 Ω
    A41-2 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)