Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR

OCCUPANT DETECTION SENSOR > INSTALLATION

for Preparation Click here


CAUTION:
  1. Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here). (w/ Front Seat Side Airbag)
  2. Wear protective gloves. Sharp areas on the parts may injure your hands.

NOTICE:
Always use "TORX" socket wrench E10 when removing the front seat.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.



1. INSTALL SEPARATE TYPE FRONT SEAT CUSHION PAD
  1. Temporarily install the separate type front seat cushion cover.



    B272775E01
  1. Using hog ring pliers, install 14 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seat cushion pad.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.

    Text in Illustration 
    *1
    New Hog Ring
    *2
    Hog Ring Pliers



    B272773E01
  1. Using hog ring pliers, install the separate type front seat cushion cover to the separate type front seat cushion pad with 2 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seat cushion pad.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.

    Text in Illustration 
    *1
    New Hog Ring
    *2
    Hog Ring Pliers



2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD


  1. Engage the 5 hooks and temporarily install the seat cushion cover with pad.


    B287794



    B287793
  1. Engage the 2 hooks.



    B283260
  1. Engage the guide to install the occupant detection sensor. (w/ Occupant Detection Sensor)



    B289866
  1. Engage the 7 clamps to install the front seat side airbag wire harness. (w/ Front Seat Side Airbag)



    B272761
  1. Engage the 4 hooks to install the seat cushion cover with pad.



    B289256
  1. Fasten the hook and loop fastener. (w/ Front Seat Side Airbag)



    B287791
  1. Connect the seatback cover band.



3. INSTALL FRONT SEAT CUSHION INNER SHIELD


    B272755
  1. Engage the 2 claws to install the front seat cushion inner shield.



4. INSTALL FRONT SEAT CUSHION SHIELD


    B287790
  1. Engage the clip and 2 claws to install the front seat cushion shield.

  1. Install the screw.



5. INSTALL RECLINING ADJUSTER RELEASE HANDLE


    B287789
  1. Engage the claw to install the reclining adjuster release handle.



6. INSTALL FRONT SEAT INNER BELT ASSEMBLY
(Click here)


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



8. INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag)
(Click here)