Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR

OCCUPANT DETECTION SENSOR > REMOVAL

for Preparation Click here


CAUTION:
  1. Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here). (w/ Front Seat Side Airbag)
  2. Wear protective gloves. Sharp areas on the parts may injure your hands.

NOTICE:
Always use "TORX" socket wrench E10 when removing the front seat.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.



1. PRECAUTION (w/ Front Seat Side Airbag)

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE FRONT SEAT INNER BELT ASSEMBLY
(Click here)


4. REMOVE RECLINING ADJUSTER RELEASE HANDLE


    B287788E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw to remove the reclining adjuster release handle.
    Text in Illustration 
    *1
    Protective Tape



5. REMOVE FRONT SEAT CUSHION SHIELD


    B287790
  1. Remove the screw.

  1. Disengage the 2 claws and clip, and remove the front seat cushion shield.



6. REMOVE FRONT SEAT CUSHION INNER SHIELD


    B272755
  1. Disengage the 2 claws to remove the front seat cushion inner shield.



7. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD


    B272772
  1. Remove the 2 hog rings.



    B272774
  1. Remove the 14 hog rings and the separate type front seat cushion cover from the separate type front seat cushion pad.



8. REMOVE SEPARATE TYPE FRONT SEAT CUSHION PAD


    B286707
  1. Remove the 2 hog rings.



    B272774
  1. Remove the 14 hog rings and the separate type front seat cushion cover from the separate type front seat cushion pad (occupant detection sensor).