NOISE FILTER > REMOVAL |
| 1. REMOVE DOOR CONTROL RECEIVER (for 5 Door) |
| 2. REMOVE DOOR CONTROL RECEIVER (for 3 Door) |
| 3. REMOVE RADIO SETTING CONDENSER |
![]() |
Remove the bolt.
Disengage the clamp and separate the condenser with the wire harness from the vehicle body.
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the terminal cover with the wire harness from the condenser.
| *1 | Protective Tape |
Using a screwdriver, bend back and break off the claw as shown in the illustration.

Remove the terminal cover from the wire harness.