Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RECEIVER (for 5 Door)

DOOR CONTROL RECEIVER (for 5 Door) > REMOVAL

for Preparation Click here



1. REMOVE DECK BOARD ASSEMBLY


    B272608
  1. Remove the deck board.



2. REMOVE SPARE WHEEL COVER


    B272609
  1. Remove the spare wheel cover.



3. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)
(Click here)


4. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)
(Click here)


5. REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type)
(Click here)


6. REMOVE REAR DOOR SCUFF PLATE LH

HINT:
Use the same procedure as for the RH side .



7. REMOVE REAR FLOOR FINISH PLATE


    B272624
  1. Disengage the 4 claws and 4 guides and remove the rear floor finish plate.



8. SEPARATE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH

HINT:
Use the same procedure as for the RH side .



9. SEPARATE REAR DOOR OPENING TRIM WEATHERSTRIP LH
  1. Separate the rear door opening trim weatherstrip.



10. REMOVE NO. 2 ROOM LIGHT ASSEMBLY (w/ Luggage Compartment Room Light)


    E222045E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw.
    Text in Illustration 
    *1
    Protective Tape

  1. Disconnect the connector and remove the No. 2 room light assembly.



11. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

HINT:
Use the same procedure as for the RH side .



12. REMOVE ROOF SIDE INNER GARNISH LH

HINT:
Use the same procedure as for the RH side .



13. REMOVE DOOR CONTROL RECEIVER


    E221626
  1. Disconnect the connector.

  1. Remove the bolt.

  1. Disengage the 2 hooks and remove the door control receiver.