CRUISE CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
| |||||
| 3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning normally.
| Result | Proceed to |
| DTC is not output | A |
| DTC is output (for Separate Type Yaw Rate Sensor) | B |
| DTC is output (except Separate Type Yaw Rate Sensor) | C |
|
| ||||
|
| ||||
| |||||
| 4.CHECK FOR DTC* |
Check for DTCs (Click here).
Clear the DTCs (Click here).
Recheck for DTCs (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
|
| ||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Road Test (Click here).
Terminals of ECM (Click here).
Data List / Active Test (Click here).
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
| |||||
| 8.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|