Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY (for Driver Side)

FRONT SEAT SIDE AIRBAG ASSEMBLY (for Driver Side) > REMOVAL

for Preparation Click here


CAUTION:
  1. Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).
  2. If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with a new one.
  3. Wear protective gloves. Sharp areas on the parts may injure your hands.

NOTICE:
Always use "TORX" socket wrench E10 when removing the front seat.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE FRONT SEAT INNER BELT ASSEMBLY
(Click here)


4. REMOVE FRONT SEAT HEADREST ASSEMBLY

HINT:
Use the same procedure as for the LHD .



5. REMOVE RECLINING ADJUSTER RELEASE HANDLE

HINT:
Use the same procedure as for the LHD .



6. REMOVE VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster)

HINT:
Use the same procedure as for the LHD .



7. REMOVE FRONT SEAT CUSHION SHIELD

HINT:
Use the same procedure as for the LHD .



8. REMOVE FRONT SEAT CUSHION INNER SHIELD

HINT:
Use the same procedure as for the LHD .



9. REMOVE FRONT SEATBACK COVER WITH PAD


    B287791
  1. Disconnect the seatback cover band.



    B287792
  1. Unfasten the hook and loop fastener.



    B289893
  1. Remove the 3 hog rings.



    B289894
  1. Remove the 3 hog rings.



    B272974
  1. Unfasten the 2 zippers. (for Sport Package)



    B272764
  1. Disengage the 4 claws to remove the 2 front seat headrest supports.



    B289856
  1. Remove the 2 nuts and the seatback bracket.

  1. Remove the front seatback cover with pad.



10. REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY


    B288456
  1. Disengage the 7 clamps.



    B272934
  1. Disengage the 2 clamps to separate the front seat side airbag wire harness.



    B287807
  1. Remove the 2 nuts and the front seat side airbag assembly.

    CAUTION:
    1. The nuts must not be reused.
    2. Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.