B1D62-POWER SEAT SWITCH STUCK
For a complete wiring diagram Refer to Section 8W.
- When Monitored:
Continuously.
- Set Condition:
When the Memory Seat Module detects the switch engaged in an active position for over 50 seconds, this code will set.
| Possible Causes |
| DRIVER SEAT SWITCH |
Diagnostic Test
1. TEST FOR INTERMITTENT CONDITIONTurn the ignition on.
With the scan tool, record and erase DTC's
Press the Seat Switch in all directions several times.
Wait one minute.
With the scan tool, read DTC's.
Does the scan tool display B1D62–POWER SEAT SWITCH STUCK?
Yes
- Replace the Driver Seat Switch as necessary.
- Perform POWER SEAT SYSTEM VERIFICATION TEST - VER 1.
No
- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
- Perform POWER SEAT SYSTEM VERIFICATION TEST - VER 1. (Refer to 8 - ELECTRICAL/POWER SEATS - DIAGNOSIS AND TESTING)