SWITCH - SUNROOF
DESCRIPTION
The power sunroof switch (1) is a combination push-button and rocker switch module mounted in the overhead console (3). The sunroof switch is a direct contact unit that is directly wired to the sunroof motor/module assembly. The sunroof switch performs the following functions:
- Power sunroof open (right side of switch pushed)
- Power sunroof closed (left side of switch pushed)
- Power sunroof vent (switch center button pushed)
The sunroof switch cannot be repaired and if damaged or inoperative must be replaced. (Refer to 8 - ELECTRICAL/POWER TOP/SWITCH - REMOVAL) for the sunroof switch removal procedure.
OPERATION
The power sunroof switch is hard wired to the sunroof motor/module assembly. The switch receives battery current from the motor/module when the ignition switch is in the RUN and ACCESSORY positions or the vehicle Accessory Delay System is active. When one of the switch positions is pressed it sends battery current back to the motor/module, signaling it to move the power sunroof to the appropriate position. The motor/module will perform one of the following functions:
- Power sunroof open (right side of switch pushed)
- Power sunroof closed (left side of switch pushed)
- Power sunroof vent (switch center button pushed)
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console from the vehicle, (Refer to 8 - ELECTRICAL/OVERHEAD CONSOLE - REMOVAL).
3. Remove the screws (3) attaching the switch (4) to the overhead console.
4. Remove the switch (4) from the overhead console.
INSTALLATION
1. Position the sunroof switch (4) onto the overhead console.
2. Install the screws (3) securing the switch (4) to the overhead console.
3. Install the overhead console into the vehicle, (Refer to 8 - ELECTRICAL/OVERHEAD CONSOLE - INSTALLATION).
4. Connect the battery negative cable.