INSTALLATION
LAMP
NOTE: Repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.
1. Position the repeater lamp lens/housing (1) close enough to the fender mounting hole (3) to access and reconnect the wire harness connector (2) to the bulb socket on the back of the lamp lens/housing.
NOTE: The same repeater lamp is used on both sides of the vehicle. Regardless of which side of the vehicle the lamp is on, when properly oriented the fixed hook tab integral to the back of the lamp housing is on the right-hand side of the lamp and the latch feature is on the left-hand side.
2. With the lamp lens/housing properly oriented, engage the hook tab on the back of the right side of the lamp with the right edge of the fender mounting hole.
3. Using hand pressure, press the left side of the lamp lens/housing into the mounting hole against the spring pressure of the latch feature until the latch snaps into place.
4. Reconnect the battery negative cable.
BULB
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.
NOTE: Repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.
1. Align the base of the bulb (3) with the socket (1).
2. Push the bulb straight into the socket until the base is firmly seated.
3. Be certain that a rubber O-ring seal (2) is properly installed and in good condition around the base of the bulb socket.
4. Align the socket and bulb with the keyed opening on the back of the repeater lamp lens/housing (4).
5. Insert the socket and bulb into the housing until the socket is firmly seated.
6. Rotate the socket clockwise about 30 degrees to lock it into place.
7. Reinstall the repeater lamp into the fender mounting hole. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - EXTERIOR/REPEATER LAMP - INSTALLATION).
8. Reconnect the battery negative cable.